RAM 1500 Van V8-5.2L CNG VIN T (1999)
camber angle is obtained.
CAMBER: Move the forward position of the pivot bar in or out. This will change the camber angle significantly and caster angle only slightly.
The camber angle should be adjusted to the service specifications. Refer to the Wheel Alignment Specifications chart. Tighten the pivot bar bolts
to 298 Nm (220 ft. lbs.).
TOE POSITION
The wheel toe position is the final adjustment.
1. Secure the steering wheel with the front wheels in the straight-ahead position. For power steering vehicles, start the engine before straightening the
wheels.
2. Loosen the tie rod adjustment sleeve clamp bolts.
Tie Rod Adjustment
3. Adjust the wheel toe position by rotating the tie rod adjustment sleeve.
4. Position the adjustment sleeve clamps so the ends are not located at the sleeve slot. Tighten the tie rod sleeve clamps to:
-
LD: 23 Nm (17 ft. lbs.)
-
HD: 35 Nm (26 ft. lbs.)
Ensure the clamp bolts are located at the underside of the sleeve.
5. Verify camber, caster and toe position.
