RAM 1500 Van V8-5.2L CNG VIN T (1999)
Fuel Pressure Regulator: Service and Repair
Fuel Filter/Fuel Pressure Regulator Replacement
REMOVAL
WARNING: THE FUEL SYSTEM IS UNDER A CONSTANT PRESSURE, EVEN WITH ENGINE OFF. BEFORE SERVICING THE
FUEL FILTER/FUEL PRESSURE REGULATOR, THE FUEL SYSTEM PRESSURE MUST BE RELEASED.
Fuel Filter/Fuel Pressure Regulator
Refer to Fuel System Pressure Release in the Fuel Delivery System.
Filter/Regulator Location
The fuel filter/fuel pressure regulator is located at top of fuel pump module on top of fuel tank.
Fuel pump module removal is not necessary for filter/regulator removal.
1. Drain fuel tank and remove tank. Refer to Fuel Tank Removal and Installation.
See: Fuel Tank/Service and Repair/Removal and Installation
2. Clean area around filter/regulator to prevent contaminants from entering pump module.
3. The fuel filter/regulator is pressed into a rubber grommet. Remove by twisting and pulling straight up.
CAUTION: Do not pull filter/regulator more than three inches from fuel pump module. Damage to coiled fuel tube (line) may result.
