RAM 1500 Van V8-5.2L CNG VIN T (1999)
Fuel Pressure Regulator: Service and Repair
Fuel Pump Module Replacement
REMOVAL
WARNING: THE FUEL SYSTEM IS UNDER A CONSTANT PRESSURE (EVEN WITH ENGINE OFF). BEFORE SERVICING FUEL
PUMP MODULE, FUEL SYSTEM PRESSURE MUST BE RELEASED.
1. Drain fuel tank and remove tank, Refer to Fuel Tank Removal and Installation.
See: Fuel Tank/Service and Repair/Removal and Installation
2. Thoroughly wash and clean area around pump module to prevent contaminants from entering tank.
Top View of Fuel Pump Module
Locknut Removal/Installation-Typical
3. The fuel pump module locknut is threaded onto fuel tank. Install Special Tool 6856 to fuel pump module locknut and remove locknut.
4. Remove module from fuel tank.
INSTALLATION
