RAM 1500 Van V8-5.2L CNG VIN T (1999)
Fuel Gauge Sender: Service and Repair
Fuel Gauge Sending Unit Replacement
Fuel Gauge Sending Unit Location-Typical Module
The fuel gauge sending unit (fuel level sensor) and float assembly is located on the side of fuel pump module. The fuel pump module is located inside of
fuel tank.
REMOVAL
1. Remove fuel tank. Refer to Fuel Tank Removal and Installation.
See: Powertrain Management/Fuel Delivery and Air Induction/Fuel Tank/Service and Repair/Removal and Installation
2. Remove fuel pump module. Refer to Fuel Pump Module Removal and Installation.
See: Powertrain Management/Fuel Delivery and Air Induction/Fuel Pump/Service and Repair
3. Unplug 4-way electrical connector.
4. Disconnect 2 sending unit wires at 4-way connector. The locking collar of connector must be removed before wires can be released from
connector. Note location of wires within 4-way connector.
Fuel Gauge Sending Unit Lock Tab/Tracks
5. The sending unit is retained to pump module with a small lock tab and notch. Carefully push lock tab to the side and away from notch while
sliding sending unit downward on tracks for removal. Note wire routing while removing unit from module.
INSTALLATION
