RAM 1500 Van V8-5.2L CNG VIN T (1999)
ASSEMBLY
1. Lubricate O-ring seal with power steering fluid.
2. Install O-ring into housing.
3. Install plug, tap lightly with a plastic mallet to seat it.
Fig. 4
4. Install retaining ring with open end 25 mm (1 inch) from access hole.
5. Adjust pitman arm shaft, refer to Over-Center Adjustment. See: Adjustments
Pitman Shaft/Seals/Bearing
DISASSEMBLY
1. Clean exposed end of pitman shaft and housing with a wire brush.
