RAM 1500 Van V8-5.2L CNG VIN T (1999)
3. Remove piston. Remove and discard piston seals (Fig. 72).
ASSEMBLY
CAUTION: Do not force valves or plugs into place during reassembly. If the valve body bores, valves and plugs are free of distortion or burrs, the
valve body components should all slide into place easily. In addition, do not overtighten the transfer plate and valve body screws during reassembly.
Overtightening can distort the housings resulting in valve sticking, cross leakage and unsatisfactory operation. Tighten valve body screws to
recommended torque only.
LOWER HOUSING
1. Lubricate valves, springs, and the housing valve and plug bores with clean transmission fluid (Fig. 71).
2. Install 3-4 timing valve spring and valve in lower housing.
3. Install 3-4 quick fill valve in lower housing.
4. Install 3-4 quick fill valve spring and plug in housing.
5. Install timing valve end plate. Tighten end plate screws to 4 Nm (35 inch lbs.) torque.
3-4 ACCUMULATOR
1. Lubricate accumulator piston, seals and housing piston bore with clean transmission fluid (Fig. 72).
2. Install new seal rings on accumulator piston.
3. Install piston and spring in housing.
4. Install end plate on housing.
TRANSFER PLATE
Fig. 73
1. Install rear clutch and rear servo check balls in transfer plate (Fig. 73).
Fig. 74
2. Install filter screen in upper housing separator plate (Fig. 74).