RAM 1500 Van V8-5.2L CNG VIN T (1999)
Fig. 90
20. Attach solenoid case connector to 3-4 accumulator with shoulder-type screw. Connector has small locating tang that fits in dimple at top of
accumulator housing (Fig. 90). Seat tang in dimple before tightening connector screw.
21. Install solenoid assembly and gasket. Tighten solenoid attaching screws to 8 Nm (72 inch lbs.) torque.
Fig. 91
22. Verify that solenoid wire harness is properly routed (Fig. 91). Solenoid harness must be clear of manual lever and park rod and not be pinched
between accumulator housing and cover.
GOVERNOR BODY, SENSOR AND SOLENOID
1. Turn valve body assembly over so accumulator side of transfer plate is facing down.
