RAM 1500 Van V8-5.2L CNG VIN T (1999)
Universal Joint: Removal and Replacement
Single cardan universal joint components are not serviceable. If worn or leaking, they must be replaced as a unit.
REMOVAL
Fig. 12
1. Scribe reference marks on the propeller shaft yokes, axle yoke, and transmission yoke before removal or component service. This will ensure
correct phasing and eliminate possible vibration.
2. Remove the propeller shaft.
3. Using a soft drift, tap the outside of the bearing assembly to loosen snap ring.
Fig. 13
4. Remove snap rings from both sides of yoke.