RAM 1500 Van V8-5.2L VIN Y (1999)
Air Door Actuator / Motor: Service and Repair
Floor Door Actuator Replacement
FLOOR - DEFROST DOOR ACTUATOR
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Remove the instrument panel assembly from the vehicle. Refer to: "Instrument Panel Gauges and Warning Indicators : Instrument Panel :
Service and Repair" See: Instrument Panel, Gauges and Warning Indicators/Instrument Cluster / Carrier/Service and Repair
Floor-Defrost Door Actuator
3. Unplug the two vacuum harness connectors from the floor-defrost door actuator located on a mount between the two defroster outlets on the left
side of the distribution duct.
Vacuum Actuator Remove/Install - Typical
4. Using a trim stick or another suitable wide flat-bladed tool, gently pry the actuator latch while pulling firmly upward on the actuator to remove the
actuator from the mount on the distribution duct.
5. Lift the actuator upward until the actuator link is almost parallel with the floor-defrost door lever, then disengage the hole on the end of the link
from the pin on the end of the lever.
6. Remove the floor-defrost door actuator from the distribution duct.
INSTALLATION
