RAM 1500 Van V8-5.2L VIN Y (1999)
Canister Purge Solenoid: Service and Repair
CANISTER PURGE SOLENOID
REMOVAL
Purge Solenoid and LDP Locations
The duty cycle purge solenoid is attached to a bracket mounted to the left-inner wheelhouse (fender).
NOTE: The purge solenoid shown in is for vehicles equipped with a Leak Detection Pump (LDP). If not equipped with an LDP, the
location/mounting is slightly different.
1. Disconnect electrical wiring connector at solenoid.
2. Disconnect vacuum harness at solenoid.
3. Remove solenoid from support bracket.
INSTALLATION
1. Install solenoid assembly to support bracket.
2. Connect vacuum harness.
3. Connect wiring connector.
