RAM 1500 Van V8-5.2L VIN Y (1999)
Fuel Rail: Service and Repair
WARNING: THE FUEL SYSTEM IS UNDER A CONSTANT PRESSURE (EVEN WITH THE ENGINE TURNED OFF). BEFORE
SERVICING THE FUEL RAIL ASSEMBLY, THE FUEL SYSTEM PRESSURE MUST BE RELEASED.
To release fuel pressure, refer to the Fuel System Pressure Release Procedure.
Fuel Rail Assembly-Typical
CAUTION: The left and right fuel rails are replaced as an assembly. Do not attempt to separate the rail halves at the connecting hose. Due to the
design of this connecting hose, it does not use any clamps. Never attempt to install a clamping device of any kind to the hose. When removing the
fuel rail assembly for any reason, be careful not to bend or kink the connecting hose.
REMOVAL
1. Remove engine cover.
2. Remove negative battery cable at battery.
3. Remove air cleaner.
4. Perform the fuel pressure release procedure.
5. Remove throttle body from intake manifold. Refer to Throttle Body removal.
A/C Compressor Support Bracket-Typical
6. If equipped with air conditioning, remove the A-shaped A/C compressor-to-intake manifold support bracket (three bolts).
