RAM 1500 Van V8-5.2L VIN Y (1999)
![background image](/dodge/ram_1500_van/v8-5.2l_vin_y/Page-2065005.png)
11.
Remove the anti-rotation tab from the new retractor assembly and then install the new retractor assembly.
12.
Install the retractor anchor bolt. Tighten the bolt to 30 ft-lbs (41 Nm)
13.
Connect the retractor electrical connector.
14.
Install the lower B-pillar trim panel.
15.
Install the upper B-pillar trim panel.
16.
Install the driver's door sill plate.
17.
Install the lower seat belt anchor bolt (Figure 3). Tighten the bolt to 17 ft-lbs (23 Nm)
18.
Install the turning loop anchor bolt. Tighten the bolt to 30 ft-lbs (41 Nm)
19.
Close the turning loop cover.
20.
Repeat Steps 1-19 for the passenger side of the vehicle.
LH Vehicles
1.
Using a small flat blade, pry the turning loop cover open.
2.
Remove the turning loop attaching bolt and disconnect the turning loop from the height adjuster.
3.
Remove the seat belt/retractor lower anchor bolt.
4.
Remove the upper B-Pillar trim panel.
5.
Remove the lower B-Pillar trim panel.
6.
Remove and discard the retractor assembly.
7.
Install the new retractor assembly.
8.
Install the lower B-pillar trim panel.
9.
Install the upper B-pillar trim panel.
10.
Install the seat belt/retractor lower anchor bolt.
Tighten the bolt to 30 ft-lbs (41 Nm)
11.
Install the turning loop anchor bolt. Tighten the bolt to 30 ft-lbs (41 Nm)
12.
Close the turning loop cover.
13.
Repeat Steps 1-12 for the other side of the vehicle.
WJ Vehicles
1.
Open the driver's door.
2.
Using a small flat blade, pry the turning loop cover open.
3.
Remove the turning loop attaching bolt and disconnect the turning loop from the height adjuster.
4.
Remove the lower seat belt anchor bolt.
5.
Remove the driver's door sill plate.
6.
Remove the lower B-Pillar trim panel.
7.
Remove and discard the retractor assembly.
8.
Install the new retractor assembly.
9.
Install the lower B-pillar trim panel.