RAM 1500 Van V8-5.2L VIN Y (1999)
3. Remove mounting stud from the sensor and shield.
4. Remove sensor and shield from differential housing.
5. Disconnect sensor wire harness and remove sensor.
INSTALLATION
1. Connect harness to sensor. Be sure seal is securely in place between sensor and wiring connector.
2. Install 0-ring on sensor (if removed).
3. Insert sensor in differential housing.
4. Install sensor shield.
5. Install the sensor mounting stud and tighten to 24 Nm (18 ft. lbs.).
6. Install the brake line on the sensor stud and install the nut.
7. Lower vehicle.
With Four Wheel Antilock Brakes
REMOVAL
1. Raise and support vehicle.
Rear Wheel Speed Sensor
2. Disconnect wire from rear sensor on axle housing.
3. Remove sensor and bracket mounting bolt and remove sensor and bracket.
INSTALLATION
1. Secure sensor wire to rear brake hose with clips provided.
2. Install sensor and mounting bracket in axle housing. Install mounting bolt and tighten to 24 Nm (18 ft. lbs.).
3. Connect wire to sensor and secure wire to mounting bracket.
4. Remove support and lower vehicle.
