RAM 1500 Van V8-5.2L VIN Y (1999)
Seals and Gaskets: Service and Repair
Rear Axle - 8 1/4 or 9 1/4 Light duty
REMOVAL
1. Remove axle shaft.
Fig. 11
2. Remove axle shaft seal from the end of the axle tube with a small pry bar.
NOTE: The seal and bearing can be removed at the same time with the bearing removal tool.
Fig. 12
3. Remove the axle shaft bearing from the axle tube with Bearing Removal Tool Set 6310, using Adapter Foot 6310-9.
INSTALLATION
NOTE: Do not install the original axle shaft seal. Always install a new seal.
1. Wipe the axle tube bore clean. Remove any old sealer or burrs from the tube.