RAM 1500 Van V8-5.9L VIN Z (1998)
Hydraulic Control Assembly - Antilock Brakes: Service and Repair
Front Antilock Valve Replacement
NOTE: If the antilock control assembly needs to be replaced, the rear axle type and tire revolutions per mile must be programed into the new Controller
Antilock Brake (CAB).
REMOVAL
1. Remove left turn signal housing.
2. Remove the extension panel under the left turn signal housing opening.
Access Cover
3. Disconnect the horn connector and remove the access cover.
4. Remove the washer reservoir mounting screws.
5. Lift up the reservoir and disconnect the pump motor connector and pump hose.
6. Remove the reservoir from the engine compartment.
7. Disconnect battery cables and remove the battery.
8. Remove the power distribution center.
9. Remove the battery and power distribution center mount.
Harness Connector Locks
10. Push the harness connectors locks to release the locks, then remove the connectors from the CAB.
