RAM 1500 Van V8-5.9L VIN Z (1998)
Wheel Speed Sensor: Service and Repair
Wheel Speed Sensor Replacement
Front
REMOVAL
1. Raise and support vehicle.
2. Disconnect speed sensor from the main harness.
Wheel Speed Sensor
3. Remove sensor mounting bolt from the steering knuckle.
4. Remove the sensor from the steering knuckle.
INSTALLATION
CAUTION: A special bolt is used to attach the sensor. Use only a factory replacement bolt.
1. Install the sensor into the steering knuckle.
2. Install mounting bolt and tighten to 15 Nm (11 ft. lbs.).
3. Connect sensor wire to main harness and ensure wire is routed away from hot or moving components.
4. Remove supports and lower vehicle.
With Rear Wheel Antilock Brakes
REMOVAL
1. Raise vehicle on hoist.
2. Remove brake line mounting nut and remove the brake line from the sensor stud.
Rear Speed Sensor Mounting
