RAM 1500 Van V8-5.9L VIN Z (1998)
Governor Body And Gasket
6. Position governor body gasket on transfer plate.
Pressure Solenoid Retainer
7. Install retainer plate on governor body and around solenoid. Be sure solenoid connector is positioned in retainer cutout.
8. Align screw holes in governor body and transfer plate. Then install and tighten governor body screws to 4 Nm (35 inch lbs.) torque.
Governor Pressure Sensor And Solenoid Connectors
9. Connect harness wires to governor pressure solenoid and governor pressure sensor.
10. Perform Line Pressure and Throttle Pressure adjustments, refer to adjustment section of this group for proper procedures.
11. Install fluid filter and pan.
12. Lower vehicle.
13. Fill transmission with recommended fluid and road test vehicle to verify repair.
