RAM 1500 Van V8-5.9L VIN Z LDC (2001)
Fig. 8 Glove Box Inner Door & Bin Remove/Install
1. Position the inner door and bin unit onto the glove box outer door.
2. Install and tighten the eight screws that secure the inner door and bin unit to the glove box outer door. Tighten the screws to 2 N.m (17 in. lbs.).
3. Install and tighten the two screws that secure the bottom of the glove box outer door to the bottom of the glove box bin. Tighten the screws to 2
N.m (17 in. lbs.).
4. Reinstall the glove box into the instrument panel.
5. Reinstall the handle and latch onto the glove box. Refer to HANDLE & LATCH.
6. Reconnect the battery negative cable.
DISASSEMBLY
The glove box bin and inner door unit and the glove box handle and latch unit are available for service. The glove box outer door and the glove box
hinge are serviced only in the complete glove box assembly.
WARNING: ON VEHICLES EQUIPPED WITH AIR-BAGS, DISABLE THE AIRBAG SYSTEM BEFORE ATTEMPTING ANY
STEERING WHEEL, STEERING COLUMN, SEAT BELT TENSIONER, OR INSTRUMENT PANEL COMPONENT DIAGNOSIS OR
SERVICE. DISCONNECT AND ISOLATE THE BATTERY NEGATIVE (GROUND) CABLE, THEN WAIT TWO MINUTES FOR THE
AIRBAG SYSTEM CAPACITOR TO DISCHARGE BEFORE PERFORMING FURTHER DIAGNOSIS OR SERVICE. THIS IS THE
ONLY SURE WAY TO DISABLE THE AIRBAG SYSTEM. FAILURE TO TAKE THE PROPER PRECAUTIONS COULD RESULT IN
ACCIDENTAL AIRBAG DEPLOYMENT AND POSSIBLE PERSONAL INJURY.
1. Disconnect and isolate the battery negative cable.
2. Remove the handle and latch from the glove box. Refer to HANDLE & LATCH.
3. Remove the glove box from the instrument panel.
4. Remove the two screws that secure the bottom of the glove box outer door to the bottom of the glove box bin.
5. Remove the eight screws that secure the inner door and bin unit to the glove box outer door.
6. Remove the inner door and bin unit from the glove box outer door.
