RAM 1500 Van V8-5.9L VIN Z LDC (2001)
1. Lubricate caliper pistons, piston seals and piston bores with clean, fresh brake fluid.
Piston Seal
2. Install new piston seals into caliper bores.
NOTE: Verify seal is fully seated and not twisted.
3. Lightly lubricate lip of new boot with silicone grease. Install boot on piston and work boot lip into the groove at the top of piston.
4. Stretch boot rearward to straighten boot folds, then move boot forward until folds snap into place.
5. Install piston into caliper bore and press piston down to the bottom of the caliper bore by hand or with hammer handle.
