RAM 1500 Van V8-5.9L VIN Z LDC (2001)
8. Through the access cover opening, remove the other two brake lines from the valve.
9. Remove the valve mounting bolt and remove the valve through access cover opening.
INSTALLATION
1. Position the valve on the mounting bracket.
2. Install the mounting bolt and tighten to 24 Nm (18 ft. lbs.).
3. Install the brake lines and tighten to 13 Nm (115 inch lbs.).
4. Install the washer reservoir in the engine compartment. Connect the pump motor connector and pump hose.
5. Install the washer reservoir mounting screws.
6. Connect the horn connector and install the access cover.
7. Install the extension panel.
8. Install left turn signal housing.
9. Fill and bleed base brake system.
