RAM 1500 Van V8-5.9L VIN Z LDC (2001)
INSTALLATION
The speed control servo is bolted to the radiator/grille support under the right headlamp.
1. Position servo to mounting bracket.
2. Align hole in cable connector with hole in servo pin. Install cable-to-servo retaining clip.
3. Insert servo mounting studs through holes in servo mounting bracket.
4. Install servo-to-servo bracket mounting nuts and tighten to 8.5 Nm (75 in. lbs.) torque.
5. Position servo assembly to body and install 2 bolts. Tighten bolts to 8.5 Nm (75 in. lbs.) torque.
6. Connect vacuum line at servo.
7. Connect electrical connector at servo.
8. Connect servo cable to throttle body. Refer to Servo Cable Removal/installation.
9. Before starting engine, operate accelerator pedal to check for any binding.
10. Install engine cover.
11. Install air cleaner housing.
12. Connect negative battery cable to battery.
