RAM 1500 Van V8-5.9L VIN Z LDC (2001)
CAUTION: When installing the serpentine accessory drive belt, the belt must be routed correctly. If not, the engine may overheat due to the
water pump rotating in the wrong direction. Refer to figure for correct engine belt routing. The correct belt with the correct length must be used.
c. Position the drive belt over all pulleys except the idler pulley (located between the generator and A/C compressor).
d. Attach a socket/wrench to the pulley mounting bolt of the automatic tensioner.
e. Rotate the socket/wrench clockwise. Place the belt over the idler pulley. Let tensioner rotate back into place. Remove wrench. Be sure belt is
properly seated on all pulleys.
f.
Install PCM. The following belt routing schematics are published from the latest information available at the time of publication. If anything
differs between these schematics and the Belt Routing Label, use the schematics on Belt Routing Label. This label is located in the engine
compartment.
8. Fill cooling system.
9. Connect battery negative cable.
10. Start and warm engine. Check for leaks.
11. Install engine cover (if A/C equipped).
