RAM 1500 Van V8-5.9L VIN Z LDC (2001)
Access Cover: Service and Repair
ENGINE COVER
REMOVAL
Fig. 2
NOTE: The engine cover is attached with screws at the rear and with latches at the dash extension (Fig. 2).
Fig. 1
1. Remove screws attaching holddown brackets to floor pan (Fig. 1).
2. Disengage latches from dash extension.
3. Remove engine cover from vehicle (Fig. 2).
INSTALLATION
NOTE: The engine cover is attached with screws at the rear and with latches at the dash extension (Fig. 2).
1. Position engine cover on floor pan.
2. Ensure seal is seated correctly.
3. Position holddown brackets on cover and install screws in floor pan finger tight.
4. Engage latches with dash panel extension.