RAM 1500 Van V8-5.9L VIN Z LDC (2001)
Fig. 24 Floor-Defrost Door Actuator
3. Unplug the two vacuum harness connectors from the floor-panel door actuator located on a mount outboard of the demister outlet on the right side
of the distribution duct.
4. Using a trim stick or another suitable wide flat-bladed tool, gently pry the actuator latch while pulling firmly outward on the actuator to remove the
actuator from the mount on the distribution duct.
5. Swing the actuator around the floor-panel door lever about 1800, or until the actuator link is at almost a right angle on the opposite side of the
lever, then disengage the hole on the end of the link from the pin on the end of the lever.
6. Remove the floor-panel door actuator from the distribution duct.
Rear Mode Control Motor
The rear mode control motor is used only on models with the optional rear heater-A/C unit. The rear mode control motor can be removed without
removing the rear heater-A/C unit from the vehicle.
1. Disconnect and isolate the battery negative cable.
2. Remove the cover from the rear heater-A/C unit.
3. Remove the vertical duct from the rear heater- A/C unit.
4. Remove the horizontal duct from the rear heater-A/C unit.
Fig. 25 Rear Mode Control Motor Remove/Install
