RAM 1500 Van V8-5.9L VIN Z LDC (2001)
Blower Motor Resistor: Testing and Inspection
The blower motor resistors used for the front heater-only or heater-A/C systems and for the optional rear heater-A/C unit can be tested in the same
manner. The front blower motor resistor is located in the engine compartment on the inboard side of the heater-A/C housing. The rear blower motor
resistor is located in lower housing of the rear heater-A/C unit in the passenger compartment.
The front blower motor resistor can be tested without removing it from its mounting position. The rear blower motor resistor must be removed from its
mounting position to be tested. For circuit descriptions and diagrams, refer to the appropriate wiring information. The wiring information includes wiring
diagrams, proper wire and connector repair procedures, details of wire harness routing and retention, connector pin-out information and location views
for the various wire harness connectors, splices and grounds.
WARNING: ON VEHICLES EQUIPPED WITH AIRBAGS, DISABLE THE AIRBAG SYSTEM BEFORE ATTEMPTING ANY STEERING
WHEEL, STEERING COLUMN, OR INSTRUMENT PANEL COMPONENT DIAGNOSES OR SERVICE. DISCONNECT AND ISOLATE
THE BATTERY NEGATIVE (GROUND) CABLE, THEN WAIT TWO MINUTES FOR THE AIRBAG SYSTEM CAPACITOR TO
DISCHARGE BEFORE PERFORMING FURTHER DIAGNOSIS OR SERVICE. THIS IS THE ONLY SURE WAY TO DISABLE THE
AIRBAG SYSTEM. FAILURE TO TAKE THE PROPER PRECAUTIONS COULD RESULT IN ACCIDENTAL AIR- BAG DEPLOYMENT
AND POSSIBLE PERSONAL INJURY.
1. Disconnect and isolate the battery negative cable.
2. Unplug the wire harness connector from the blower motor resistor.
3. Check for continuity between each of the blower motor switch input terminals of the resistor and the resistor output terminal. In each case there
should be continuity. If OK, repair the wire harness circuits between the blower motor switch and the blower motor resistor or blower motor as
required. If not OK, replace the faulty blower motor resistor.
