RAM 1500 Van V8-5.9L VIN Z LDC (2001)
Blower Motor Resistor: Service and Repair
REMOVAL
Front
1. Disconnect and isolate the battery negative cable.
Fig. 18 Front Blower Motor Resistor Remove/Install
2. Unplug the wire harness connector from the blower motor resistor, which is located on the inboard side of the heater-A/C housing.
3. Remove the two screws that secure the blower motor resistor to the heater-A/C housing.
4. Remove the front blower motor resistor from the heater-A/C housing.
Rear
The rear blower motor resistor is used only on models with the optional rear heater-A/C unit.
1. Before beginning this procedure, place the rear heater-A/C unit in the heat mode by turning the ignition switch to the ON position and placing the
temperature control knob on the heater-A/C control in the full hot position.
2. Turn the ignition switch to the OFF position. Disconnect and isolate the battery negative cable.
3. Remove the cover from the rear heater-A/C unit.
4. Reach under the front of the rear heater-A/C unit to access and unplug the wire harness connector from the rear blower motor resistor.
5. Remove the horizontal duct from the rear heater-A/C unit.
