RAM 1500 Van V8-5.9L VIN Z LDC (2001)
Blower Motor Switch: Service and Repair
REMOVAL
The rear blower motor switch is used only on models with the optional rear heater-A/C unit.
1. Disconnect and isolate the battery negative cable.
2. Remove the accessory switch plate from the instrument panel.
Fig. 20 Rear Blower Motor Switch Remove/Install
3. Rotate the illumination lamp socket counterclockwise to disengage it from the back of the switch housing.
4. Pull the knob off of the blower motor switch stem from the front of the accessory switch plate.
5. With a small thin-bladed screwdriver, gently pry the sides of the accessory switch plate to release the two snap clips on each side of the rear
blower motor switch housing.
6. Remove the rear blower motor switch from the back of the accessory switch plate.
INSTALLATION
The rear blower motor switch is used only on models with the optional rear heater-A/C unit.