RAM 1500 Van V8-5.9L VIN Z LDC (2001)
Fig. 8 Fuel Gauge Sending Unit Lock Tab/Tracks
5. The sending unit is retained to pump module with a small lock tab and notch (Fig. 8). Carefully push lock tab to the side and away from notch
while sliding sending unit downward on tracks for removal. Note wire routing while removing unit from module.
INSTALLATION
The fuel gauge sending unit (fuel level sensor) and float assembly is located on the side of fuel pump module (Fig. 7). The fuel pump module is
located inside of fuel tank.
1. Position sending unit into tracks. Note wire routing.
2. Push unit on tracks until lock tab snaps into notch.
3. Connect 2 sending unit wires into 4-way connector and install locking collar.
4. Connect 4-way electrical connector to module.
5. Install fuel pump module. Refer to Fuel Pump Module Removal/installation.
6. Install fuel tank. Refer to Fuel Tank Removal/Installation.
