RAM 1500 Van V8-5.9L VIN Z LDC (2001)
Combination Switch: Testing and Inspection
WARNING: ON VEHICLES EQUIPPED WITH AIRBAGS, DISABLE THE AIRBAG SYSTEM BEFORE ATTEMPTING ANY STEERING
WHEEL, STEERING COLUMN, SEAT BELT TENSIONER, OR INSTRUMENT PANEL COMPONENT DIAGNOSIS OR SERVICE.
DISCONNECT AND ISOLATE THE BATTERY NEGATIVE (GROUND) CABLE, THEN WAIT TWO MINUTES FOR THE AIRBAG
SYSTEM CAPACITOR TO DISCHARGE BEFORE PERFORMING FURTHER DIAGNOSIS OR SERVICE. THIS IS THE ONLY SURE
WAY TO DISABLE THE AIRBAG SYSTEM. FAILURE TO TAKE THE PROPER PRECAUTIONS COULD RESULT IN ACCIDENTAL
AIRBAG DEPLOYMENT AND POSSIBLE PERSONAL INJURY.
1. Remove the multi-function switch from the switch mounting housing on the steering column. (Refer to LAMPS/LIGHTING -
EXTERIOR/MULTI-FUNCTION SWITCH - REMOVAL).
Fig. 18 Multi-Function Switch Tests
2. Using an ohmmeter, perform the continuity and resistance tests at the terminals in the multi-function switch connector receptacle as shown in the
Multi-Function Switch Tests chart.
3. If the multi-function switch fails any of the continuity or resistance tests, replace the faulty switch unit as required.
