RAM 1500 Van V8-5.9L VIN Z LDC (2001)
INSTALLATION
1. Install park gear into rear support so crown on curved boss is in line with hole through output shaft.
2. Install governor filter in park gear.
3. Slip governor body over output shaft and align port to filter.
4. Install bolts to hold governor body to park gear. Tighten bolts to 11 Nm (95 inch lbs.) torque (Fig. 110).
5. Install governor body-park gear snap-rings and washer on output shaft as follows:
a. Install thin snap-ring first. Then install thrust washer second, and thick snap-ring last (Fig. 109).
b. Verify correct position of snap-rings. Be sure flat side of each snap-ring is toward governor body.
