RAM 1500 Van V8-5.9L VIN Z LDC (2001)
2. Assemble regulator valve line pressure plug, sleeve, throttle plug and spring. Insert assembly in upper housing and install cover plate. Tighten
cover plate screws to 4 Nm (35 inch lbs.) torque.
3. Install 1-2 and 2-3 shift valves and springs.
4. Install 1-2 shift control valve and spring.
5. Install retainer, spring, limit valve, and 2-3 throttle plug from limit valve housing.
6. Install limit valve housing and cover plate. Tighten screws to 4 Nm (35 inch lbs.).
7. Install shuttle valve as follows:
a. Insert plastic guides in shuttle valve secondary spring and install spring on end of valve.
b. Install shuttle valve into housing.
c. Hold shuttle valve in place.
d. Compress secondary spring and install E-clip in groove at end of shuttle valve.
e. Verify that spring and E-clip are properly seated before proceeding.
8. Install shuttle valve cover plate. Tighten cover plate screws to 4 Nm (35 inch lbs.) torque.
9. Install 1-2 and 2-3 valve governor plugs in valve body.
10. Install shuttle valve primary spring and throttle plug.
11. Align and install governor plug cover. Tighten cover screws to 4 Nm (35 inch lbs.) torque.
BOOST VALVE TUBE AND BRACE
1. Position valve body assembly so lower housing is facing upward (Fig. 324).
2. Lubricate tube ends and housing ports with transmission fluid or petroleum jelly.
3. Start tube in lower housing port first. Then swing tube downward and work opposite end of tube into upper housing port (Fig. 324).
4. Insert and seat each end of tube in housings.
5. Slide tube brace under tube and into alignment with valve body screw holes (Fig. 325).
6. Install and finger tighten three screws that secure tube brace to valve body housings (Fig. 325).
