RAM 2500 Truck 2WD L6-359 5.9L DSL Turbo VIN D FI (1997)
NOTE: To aid in the removal of the trim panel, start at the bottom of the panel.
Door Mounted Speaker Remove/Install
10. Remove the screws that secure the speaker(s) to the inner door panel.
11. Unplug the speaker wire harness connector and remove the speaker from the door.
12. When installing the power window and lock switch bezel to the door trim panel, insert the rear of the bezel into the trim panel opening, then push
down on the front of the bezel until the retaining tab snaps into place.
13. Reverse the remaining removal procedures to complete the installation.
Rear Cab Side Panel
1. Disconnect and isolate the battery negative cable.
2. Remove the rear cab side panel trim.
3. Move the side panel trim away from the cab side far enough to access the speaker.
4. Remove the screws that secure the speaker to the rear cab side.
5. Pull the speaker out from the rear cab side far enough to access and unplug the speaker wire harness connector.
6. Remove the speaker from the rear cab side panel.
7. Reverse the removal procedures to install.
