RAM 2500 Truck 2WD L6-359 5.9L DSL Turbo VIN D FI (1997)
Brake Pad: Service and Repair
Cleaning and Inspection
BRAKE PAD LINING INSPECTION
Measure brake pad lining thickness. Replace riveted lining if worn to within 1.5 mm (1/16 inch) of rivet heads. Replace bonded lining if thickness
is 3 mm (3/16 inch) or less.
NOTES:
-
Remove one of the front wheels and inspect the brake disc, caliper and linings. The wheel bearings should be inspected at this time and
repacked if necessary.
-
Do not get any oil or grease on the linings. It is recommended that both front wheel sets be replaced whenever a respective pad is worn or
damaged. Inspect and, if necessary, replace rear brake linings also.
-
If the caliper is cracked or fluid leakage through the casting is evident, it must be replaced as a unit.
