RAM 2500 Truck 2WD L6-359 5.9L DSL Turbo VIN D FI (1997)
1.
If the alignment angles are within specifications, continue to step 7, if not, continue to the next step (step 2).
Correcting Thrust Angle
2.
CORRECTING THRUST ANGLE
a.
If thrust angle is incorrect, raise the vehicle on an appropriate frame support style lift (rear axle must be allowed to extend fully).
b.
Support the axle to remove all weight from springs and yet not support any weight of the vehicle.
c.
Inspect the part number of both leaf springs. If both springs have the same part number, proceed to the next step. If the part numbers are
different from side to side, then incorrect thrust angle could be caused by having springs of different lengths. Verify that the springs are of
the same length by measuring the springs from the front spring eye to the rear spring eye (service part numbers may have different part
numbers then production part numbers). If springs are of different lengths, install the correct springs and recheck thrust angle. Refer to the
appropriate Service Manual for information regarding rear spring service.
d.
Loosen the nuts from the spring clamp bolts that attach the spring to the axle (Figure 3).
