RAM 2500 Truck 2WD L6-359 5.9L DSL Turbo VIN D FI (1997)
CAUTION: A number or letter is stamped into the tongue of constant tension clamps. If replacement is necessary, use only an original equipment
clamp with matching number or letter.
NOTE: For all vehicles: In areas where specific routing and clamps are not provided, be sure that hoses are positioned with sufficient clearance. Check
clearance from exhaust manifolds and pipe, fan blades, drive belts and sway bars. Improperly positioned hoses can be damaged, resulting in coolant loss
and engine overheating.
CLAMPS
Ordinary worm gear type hose clamps (when equipped) can be removed with a straight screwdriver or a hex socket. To prevent damage to hoses or
clamps; the hose clamps should be tightened to 4 Nm (34 inch lbs.) torque. Do not over tighten hose clamps.