RAM 2500 Truck 2WD L6-359 5.9L DSL Turbo VIN D FI (1997)
Fig 20 Rotor Installer Set
INSTALLATION
1. Install the clutch field coil and snap ring.
2. Install the clutch coil wire harness retainer clip on the compressor front housing and tighten the retainer screw.
3. Align the rotor assembly squarely on the front compressor housing hub.
4. Thread the handle (Special Tool 6464 in Kit 6460) into the driver (Special Tool 6143 in Kit 6460).
Fig 21 Rotor Installation
5. Place the driver tool assembly into the hearing cavity on the rotor. Make certain the outer edge of the tool rests firmly on the rotor hearing inner
race.
6. Tap the end of the driver while guiding the rotor to prevent binding. Tap until the rotor bottoms against the compressor front housing hub. Listen
for a distinct change of sound during the tapping process to indicate the bottoming of the rotor.
7. Install the external front rotor snap ring.