RAM 2500 Truck 2WD L6-359 5.9L DSL Turbo VIN D FI (1997)
20.
Unscrew and discard the old ball stud and retaining nut from the throttle lever (Figure 6).
21.
Install a new ball stud onto the throttle lever in the same position as the original ball stud (Figure 6). Tighten the new ball stud nut to 80 in. lbs. (9
Nm).
22.
Remove the original throttle rod ends from the throttle rod (Figure 7).
23.
Match the new throttle rod ends to the old throttle rod ends. Install the new throttle rod ends onto the original throttle rod. The rod end openings
must be oriented as shown in Figure 7.
24.
Tighten the secondary bellcrank rod end lock nut to 80 in. lbs. (9 Nm) (Figure 7).
25.
Install the throttle control rod end onto the secondary bellcrank ball stud.
CAUTION:
