RAM 2500 Truck 2WD L6-359 5.9L DSL Turbo VIN D FI (1997)
g.
Select "SENSOR DISPLAY" and press enter.
h.
The voltage at the TPS should be 1.0 volt (+/- 0.2 volts) with the linkage in the idle position. At Wide Open Throttle (WOT), the output
voltage of the TPS must be 2.2-to-2.9 volts higher than at idle speed. If voltage is not correct, recheck the linkage adjustment.
CAUTION:
Do not lengthen or shorten the linkage rod more than 3/64 inch (1 mm) from the dimension shown in Figure 8.
41.
Install the charge air cooler-to-air horn tube. Position the band clamps and tighten to 95 in. lbs. (11 Nm).
42.
Start the engine and verify proper throttle operation.