RAM 2500 Truck 2WD L6-359 5.9L DSL Turbo VIN D FI (1997)
5. From the underside of the steering wheel, remove the four nuts that secure the airbag module to the steering wheel.
6. Pull the airbag module away from the steering wheel far enough to unplug the airbag module wire harness connector from the back of the airbag
module.
7. Remove the airbag module from the steering wheel.
8. If the airbag has been deployed, see the procedure for replacing the clockspring.
9. When installing the airbag module, connect the clockspring wire harness connector to the module by pressing straight in on the connector.
10. Install the four airbag module mounting nuts and tighten to 9 to 11 N.m (80 to 100 in. lbs.).
11. Install the vehicle speed control switch or trim bar, as equipped.
12. Do not connect the battery negative cable at this time. See Testing and Inspection/Procedures for the proper procedures.
