RAM 2500 Truck 2WD L6-359 5.9L DSL Turbo VIN D FI (1997)
Headlamp Switch: Service and Repair
REMOVAL
WARNING: IF THE HEADLAMP SWITCH WAS TURNED ON, WAIT FIVE MINUTES TO ALLOW THE CERAMIC DIMMER
RESISTOR TO COOL. IF THE RESISTOR IS NOT ALLOWED TO COOL, IT CAN BURN YOUR FINGERS.
1. Remove the cluster bezel.
Headlamp Switch And Bezel Remove/Install
2. Remove the three screws that secure the headlamp switch bezel to the instrument panel.
Headlamp Switch Knob And Shaft Remove/Install
3. Pull the headlamp switch and bezel out from the instrument panel far enough to unplug the wire harness connectors.
4. Pull the headlamp switch control knob out to its On position stop.
5. Depress the headlamp switch knob and shaft release button on the bottom of the switch, and pull the switch knob and shaft out of the switch.
6. Remove the two screws that secure the headlamp switch bezel to the switch mounting bracket.
7. Reverse the removal procedures to install.
