RAM 2500 Truck 2WD L6-359 5.9L DSL Turbo VIN D FI (1997)
Clutch Release Bearing: Service and Repair
REMOVAL
1. Remove transmission and transfer case, if equipped.
2. On models with gas engine and new style release fork, remove clutch housing for access to release fork and release bearing retainer springs.
3. Disconnect release bearing from release fork and remove bearing.
INSTALLATION
1. Inspect bearing slide surface on transmission front bearing retainer. Replace retainer if slide surface is scored, worn, or cracked.
2. Inspect release lever and pivot stud. Be sure stud is secure and in good condition. Be sure fork is not distorted or worn. Replace fork spring clips if
bent or damaged.
3. Lubricate crankshaft pilot bearing, input shaft splines, bearing retainer slide surface, lever pivot ball stud, and release lever pivot surface with
MOPAR high temperature bearing grease.
4. Install release fork and release bearing. Be sure fork and bearing are properly secured by spring clips.
5. Install clutch housing, if removed.
6. Install transmission and transfer case, if equipped.