RAM 2500 Truck 2WD L6-359 5.9L DSL Turbo VIN D FI (1997)
4. Verify that disc hub is positioned correctly. Side of hub marked Flywheel Side should face flywheel.
5. Insert alignment tool in pilot bearing and position disc on flywheel surface.
6. Position clutch cover over disc and onto flywheel.
7. Align and hold clutch cover in position and install cover bolts finger tight.
8. Tighten cover bolts evenly and a few threads at a time. Cover bolts must be tightened evenly and to specified torque to avoid distorting cover.
9. Tighten clutch cover bolts to following:
-
5/16 inch diameter bolts to 23 Nm (17 ft. lbs.).
-
3/8 inch diameter bolts to 41 Nm (30 ft. lbs.).
10. Remove release lever and release bearing from clutch housing. Apply MOPAR high temperature bearing grease to bore of release bearing, release
lever contact surfaces, and release lever pivot stud.