RAM 2500 Truck 2WD L6-359 5.9L DSL Turbo VIN D FI (1997)
21. Install first speedometer snap ring on shaft, followed by speedometer gear. Then install second snap ring to secure gear on shaft.
22. Install output bearing on mainshaft. Be sure groove in outer race of bearing is toward rear of shaft. If bearing is reversed, retaining ring (in
extension) will not align bearing.
23. Install output bearing retaining ring. Use parallel jaw pliers to install ring.
24. Install new seal in rear extension if necessary. Use suitable size installer tool and be sure seal is fully seated.
25. Apply bead of MOPAR Gasket Maker, Loctite 518, or MOPAR silicone adhesive sealer to mating surface of front case and rear extension. Sealer
beads should be no more than 1/8 to 3/16 inch wide.