RAM 2500 Truck 2WD L6-5.9L DSL Turbo (2008)
11. Connect the exhaust pipe to the turbocharger and tighten the bolts to 11 N-m (100 in. lbs.).
12. Connect the wastegate command valve connector.
13. Lower the vehicle.
14. Pre-lube the turbocharger. Pour 50 to 60 cc (2 to 3 oz.) clean engine oil in the oil supply line fitting on the turbo. Rotate the turbocharger impeller
by hand to distribute the oil thoroughly.
15. Install and tighten the oil supply line fitting nut to 24 N-m (18 ft. lbs.).
16. Position the charge air cooler inlet pipe to the turbocharger. With the clamp in position, tighten the clamp nut to 11 Nm (95 in. lbs.).
17. Position the air inlet hose to the turbocharger. Tighten the clamp to 4 N-m (35 in. lbs.).
18. Connect the battery negative cables.
19. Start the engine to check for leaks.
