RAM 2500 Truck HVAC Blend Door Actuator Removal - Page 10384
Air Door Actuator / Motor: Service and Repair
Blend Door Actuator - Installation
INSTALLATION
NOTE: The single zone heating-A/C system is equipped with a single blend door actuator. The dual zone system has two blend door actuators,
one for the driver side blend-air door and one for the passenger side blend-air door.
SINGLE ZONE/DUAL ZONE DRIVER SIDE
1. Install the blend door actuator (1) onto the back of the HVAC housing (2). If necessary, rotate the actuator slightly to align the splines on the
actuator output shaft (3) with those on the blend door lever (4).
2. Install the screws (1) that secure the blend door actuator (2) to the HVAC housing (3). Tighten the screws to 1.1 Nm (10 in. lbs.).
3. Connect the HVAC wire harness connector (4) to the blend door actuator.
4. Install the instrument panel See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and Repair/Instrument Panel -
Installation .
5. Reconnect the negative battery cable.
DUAL ZONE PASSENGER SIDE
