RAM 2500 Truck 2WD L6-5.9L DSL Turbo (2008)
Bulb - Cab and Chassis
BULB - CAB AND CHASSIS
CAUTION: Always use the correct bulb size and type for replacement. An incorrect bulb size or type may overheat and cause damage to the
lamp, the socket or the lamp wiring.
NOTE: The rear lamp unit contains two bulbs: the park/turn signal/brake/license plate, and the backup. The service procedures for each bulb
are the same, only the bulb sizes and types may differ.
1. Align the base of the backup lamp bulb (4), or the park/turn signal/brake/license plate lamp bulb (7) with its socket (3) or (6).
2. Push the bulb straight into the socket until the base is firmly seated, then rotate the bulb clockwise about 30 degrees to lock it into place.
3. Position the lens (2) to the rear lamp unit housing (5).
4. Install and tighten the four screws (1) that secure the lens to the housing. Tighten the screws to 2 Nm (20 in. lbs.).
5. Reconnect the battery negative cable.
Bulb - Pick-Up
BULB - PICK-UP
CAUTION: Always use the correct bulb size and type for replacement. An incorrect bulb size or type may overheat and cause damage to the
lamp, the socket or the lamp wiring.
NOTE: The rear lamp unit contains two bulbs: park/stop/turn signal/side marker and backup. The service procedures for each bulb are the
same, only the bulb sizes and types may differ.
1. Align the base of the bulb with the park/stop/turn signal/side marker (2) or the backup (4) bulb socket.
2. Push the bulb straight into the socket until the base is firmly seated.
3. Align the socket and bulb with the keyed opening on the back of the rear lamp unit housing (1).
4. Insert the socket and bulb into the housing until the socket is firmly seated.
5. Rotate the socket clockwise about 30 degrees to lock it into place.
