RAM 2500 Truck 2WD L6-5.9L DSL Turbo (2008)
3. Rear 4X2 LD - On each side of the vehicle, measure the distance at the axle tube (1) to the jounce bumper flange (2).
4. Rear 4X4 LD - On each side of the vehicle, measure the distance at the jounce pad welded to the axle tube (1) to the jounce bumper flange (2).
5. Compare the measurements to the specifications listed in the following Curb Height Specifications chart.
Curb Height Measurement (HD)
CURB HEIGHT MEASUREMENT (HD)
The wheel alignment is to be checked and all alignment adjustments made with the vehicle at its required curb height specification.
Vehicle height is to be checked with the vehicle on a flat, level surface, preferably a vehicle alignment rack. The tires are to be inflated to the
recommended pressure. All tires are to be the same size as standard equipment. Vehicle height is checked with the fuel tank full of fuel, and no passenger
or luggage compartment load.
Inspect the vehicle for bent or weak suspension components. Compare the parts tag on the suspect coil spring(s) to the parts book and the vehicle sales
code, checking for a match. Once removed from the vehicle, compare the coil spring height to a correct new or known good coil spring. The heights
should vary if the suspect spring is weak.
1. Front 4X2 On each side of the vehicle, measure the distance from the top of the jounce bumper flange (2) to the bottom of the frame rail (1).
