RAM 2500 Truck 2WD L6-5.9L DSL Turbo (2008)
O-ring.
c. Remove filter element by twisting element sideways from filter lid.
6. Water-In-Fuel (WIF) Sensor Replacement: The WIF sensor (5) is located on the side of the fuel filter housing.
a. Disconnect electrical connector at sensor.
b. Clean area around sensor.
c. Remove sensor by rotating counterclockwise.
d. Check condition of sensor O-ring. Replace if damaged.
7. Fuel Heater Element Replacement: The heater element (2) is located in the fuel filter housing.
a. Remove fuel filter. See previous steps.
b. Disconnect electrical connector.
c. Remove two T-15 Torx head mounting screws (3) from fuel heater element.
d. Remove fuel heater.
