RAM 2500 Truck 2WD L6-5.9L DSL Turbo (2008)
6. Connect electrical wiring connector to ESIM switch (3).
7. If equipped, install necessary skid plates.
8. All vapor/vacuum lines and hoses must be firmly connected. Also check the vapor/vacuum lines at the EVAP canister purge solenoid for
damage or leaks. If a leak is present, a Diagnostic Trouble Code (DTC) may be set.
9. Lower vehicle.
Type-4 Canisters
CAUTION: After installing any EVAP canister or ESIM switch, the electrical connector on the switch MUST be in the 3 O'clock position (as
viewed from front). This step must be done for proper ESIM switch operation.
Dual, horizontally mounted EVAP canisters (1) and (7) are used with Type 4. The ESIM (Emission System Integrity Monitor) switch (3) is mounted to
the main, primary canister (1). Canister (7) is considered a secondary canister.
1. Position two secondary canister locating pins into mounting bracket. Install mounting nut (6).
2. Position two primary canister locating pins into mounting bracket.
3. Install primary canister mounting bracket nut (9).
4. Connect quick-connect vapor line (8) to main canister.
5. Connect vapor line (5) to ESIM switch.
6. Connect electrical wiring connector to ESIM switch (4).
7. If equipped, install necessary skid plates.
8. All vapor/vacuum lines and hoses must be firmly connected. Also check the vapor/vacuum lines at the EVAP canister purge solenoid for
damage or leaks. If a leak is present, a Diagnostic Trouble Code (DTC) may be set.
9. Lower vehicle.
