RAM 2500 Truck 2WD L6-5.9L DSL Turbo (2008)
3. Install the inner tie rod end boot (2) and reclamp (1&3) to the tie rod (4) and rack.
4. Install the jam nut (1) to the inner tie rod end (2).
5. Install the outer tie rod (3) the same number of turns when removed See: .
6. Install the front wheels.
7. Lower the vehicle.
8. Perform toe adjustment.
9. Tighten the jam nut (1) after toe adjustment. Tighten to 50 Nm (37 ft. lbs.).
Link/Coil
INSTALLATION
1. Install tie rod (2) to the left steering knuckle and drag link. Install the nuts (1) and tighten to 54 Nm (40 ft. lbs.) Then an additional 90°.
2. Remove the supports and lower the vehicle to the surface. Center steering wheel and adjust toe, See: Alignment/Service and Repair .
3. After adjustment tighten tie rod adjustment sleeve clamp bolts to 61 Nm (45 ft. lbs.).
NOTE: Position the clamp on the sleeve so retaining bolt is located on the bottom side of the sleeve.